Spa 2 Go Portable Spa

Sets-up in Minutes, Truly Portable! Enjoy a relaxing whirlpool Spa wherever you like, without complicated or costly installation. This portable unit is ready to use in just minutes, yet has all the vigorous heated jet-action of permanently installed models - at a fraction of the cost!

Spa-2-Go features durable K80 vinyl construction that uses the same resilient material found in white water rafts, to deflect pulling, tearing and punctures. Inflates in just 10 minutes using accompanying motor. Then plug into a standard 110V outlet & fill from your garden hose! Digital control panel allows you to adjust temperature with the touch of a button. And the Spa's filter unit ensures water stays clear & fresh.

Specifications & Dimensions

• Seating for four adults
• Outside Diameter 74" (w/ powerpak, 98")
• Inner Diameter 58"
• Height 28"
• 250 gallon capacity
• 1.3 HP Turbo Wave Massage System
• 127 Micro-Air Jets
• 15 sq.ft. Filtration system
• Insulair Locking Thermal Cover Included
• Thermostatically Controlled 1kw Heater
• Built-in seats, cushioned side panels for reclining comfort

Assembly Instructions

Step 1
Unfold the Liner of your Spa-2-Go; spread it out into a flat position.

Step 2
Connect the inflator hose (included) to the power-pack on the air blower side (right) to inflate the Spa. Inflate the three valves, plus the interior floor.

Step 3
Connect all three power-pack fittings to the Spa (hand tighten only!). Then fill your Spa, using a garden hose.

Step 4
Use the inflator hose (included) to inflate the insulation bladder.

Step 5
Place the inflated insulation bladder over the filled Spa. Push down on all sides to ensure a tight fit.

Step 6
Place the top over the Spa; line up the eight cover locks.